[ Pobierz całość w formacie PDF ]
40-1
j
a
t
Front axle components, overview
General Information
Load bearing components and parts of the suspension
must not be welded or straightened.
Vehicles without drive axle must not be moved, or wheel
bearing will be damaged. If vehicle does have to be
moved, always note the following points:
Advanced
Search
Search
-
Install an outer joint in place of the drive
axle.
Version: 2.5r01sp0003
-
Tighten outer joint to 115 Nm (M14 bolt) or 190 Nm
(M16 bolt).
Bonded rubber bushings can only be turned to a limited
extent. The bolted connections on suspension links
should only be tightened when vehicle is standing on
the ground.
40-2
Threads in longmember, servicing
Servicing thread in weld nuts in longmember is possible
under certain circumstances.
Servicing must only be performed once per
thread.
If secondary servicing is required, the weld nut must
be replaced.
WARNING!
Wear protective glasses when drilling!
Have responsible foreman or next superior check
thread repair.
Thread insert must have same length as thread in
body.
Repair possible damage to underbody; applicable
notes can be found in:
Repair Manual, Body Collision Repair, Repair Group
00; Corrosion protection measures
40-3
Component overview
1 - Hex bolt, 75 Nm
2 - Washer
3 - Hex bolt M10 x 62
Always replace
after disassembly
4 - Upper rear link
Replace
bushing
Separating from
wheel bearing
housing
Page 40-
15
5 - Hex bolt, 5 Nm
Bolt onto
system
6 - Bolt
7 - Self-locking nut
Always replace
after disassembly
50 Nm for steel
wheel bearing
housing
45 Nm for
aluminium wheel
bearing housing
8 - Hex bolt M10 x 100
[ Pobierz całość w formacie PDF ]

Wątki

Search